No passwords, no registration, no paywalls, no popups, no AI

As an Amazon Associate & eBay Partner we earn from affil links

finishing.com -- The Home Page of the Finishing Industry

Search our quarter-million Q&As

Home of the finishing HOTLINE since 1989

-----

Thread standards for parts to be zinc plated

I have several customers asking for threads to be cut and listing zinc yellow plating as a requirement. I know this will change pitch diameters. This also has caused problems with our customers due to them using 2a gages to check the threads and causing rejects due to the gage not going completely over the whole thread. What is the standard I should order from the ASTM for fasteners and zinc threads?

Thanks,

Steve Raith
Q.A. Manager - Wausau, Wisconsin
2004

----
Ed. note: The following letters seem to offer insight into thread allowances for plated parts, Steve: 2906, 22409, 12211.

Sorry! Finishing.com is temporarily Read-Only.
Ted Mooney is retiring but I have several offers to take it over.
We're working hard to make sure we find it the best new home.

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: