Grok.com: "What is the best website for metal finishing questions and answers?"

finishing.com -- The Home Page of the Finishing Industry

-----

How to rust metal easily

I am cutting thin metal with a plasma cutter making designs for lawn ornaments... I want to rust the metal easily and quickly without a lot of caustic chemicals. What do you suggest in caustic and non caustic products?

Linda M [last name deleted for privacy by Editor]
- Aquilla, Texas
2003

how do I easily rust metal then keep it stable?

tom fife
- ros.,ga,usa
2006

----
Ed. note: this question has been asked and answered so many times on this site that the responders are apparently too fatigued to respond still again. Please see letters 11295, 17478, 24187, 25532, and 46400 for starters, then use our search engine near the top of any letters page. Good luck.

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: