finishing.com -- The Home Page of the Finishing Industry
A website for Serious Education, promoting Aloha,
& the most FUN smiley you can have in metal finishing

HomeFAQsBooksHelpWantedAdvertiseForum
topic 568

Want plans for plating power supplies / rectifiers


(1996)

I would like to see plans on how power supplies are built.
Both standard rectifiers and pulse plating units.

Richard Pupello
merchandiser


(1996)

See Radio Shack, Archer, Building Power Supplies, Cat. No. 276-5025, It's only 5 or 8 dollars.

tom pullizzi monitor
Tom Pullizzi
Falls Township,
   Pennsylvania 


December 1, 2008

Hi, Richard. This is a popular subject. Please see letter 32439 for a start. Good luck.

Regards,

Ted Mooney, finishing.com Teds signature
Ted Mooney, P.E. RET
finishing.com
Pine Beach, New Jersey



This public forum has 60,000 threads. If you have a question in mind which seems off topic to this thread, you might prefer to Search the Site

ADD a Q or A to THIS thread START a NEW THREADView This Week's HOT TOPICS

Disclaimer: It's not possible to diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations may be deliberately harmful.

  If you need a product/service, please check these Directories:

JobshopsCapital Equip. & Install'nChemicals & Consumables Consult'g, Train'g, SoftwareEnvironmental ComplianceTesting Svcs. & Devices


©1995-2017 finishing.com     -    Privacy Policy
How Google uses data when you visit this site.