The Last Stand of the web we knew & loved: no cost, no reg'n, no popups
As an Amazon Associate & eBay Partner: we earn from qualifying purchases

finishing.com -- The Home Page of the Finishing Industry

-----

Texturing for plastic injection molds

2001

We are trying to etch alloy steel for plastic molds to give it various textures. Is there a method to do this without getting into the photoresist technique? Our idea is to repair damages in surfaces already textured and try to copy the existing pattern as much as possible.

Share of technical knowledge appreciated.

Also open to consultation offers.

Guillermo Marrufo
Monterrey, NL, Mexico

We have been involved in the headlamp mold coating business for several years. There are varying degrees of quality from providers in texturing. Their systems that can mimic any previous texture, mask areas to be left alone, etc. Hope this helps.

Blair Woodring
- East Petersburg, Pennsylvania, USA
2001

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: