No passwords, no registration, no paywalls, no popups, no AI

As an Amazon Associate & eBay Partner we earn from affil links

finishing.com -- The Home Page of the Finishing Industry

Search our quarter-million Q&As

Home of the finishing HOTLINE since 1989

-----

Hard Anodising of Specific Alloys

What is the recommended hard anodising process for 7075 and 2015 alloys?

A.Burbidge
- Banbury Oxfordshire, England
2001

Hard anodising of different alloys are carried out in 15 to 20% sulfuric acid solution at 0 to -5 °C. The voltage to be increased slowly and the final voltage and time depends on the desired thickness.

Eg. 50 to 75 micron thick can be obtained at about 30 to 33V final voltage. It would take about 2 to 2 1/2 hr time for obtaining this thickness.

Dr. H B Rudresh
- Bangalore, India
2006

Sorry! Finishing.com is temporarily Read-Only.
Ted Mooney is retiring but I have several offers to take it over.
We're working hard to make sure we find it the best new home.

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: