The Last Stand of the web we knew & loved: no cost, no reg'n, no popups
As an Amazon Associate & eBay Partner: we earn from qualifying purchases

finishing.com -- The Home Page of the Finishing Industry

-----

Stress induced cracks after ABS molding parts meant for Chrome plating

December 31, 2009

One of the molded parts which is around 1.5 mts long is showing cracks when tested by dipping in acetic acid ⇦ on eBay or Amazon [affil links] as a test to ensure the ABS molded part will be free of molding stresses to help in getting a better chrome plated part.

Kindly give some reasons why and probable solutions for the same

Regards,

Deepak Amaresh
product designer - PUNE, Maharastra, India

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: