Aloha, fun & authoritative answers -- no cost, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Metal finishing Q&As since 1989

-----

Repainting Black Anodizing

I manufacture a piece of industrial equipment that uses black anodized parts. These parts have faded from UV exposure and I want to repaint them to "clean-up" the machine's look.

I can't disassemble the system to re-anodize, so does anyone have a good suggestion for an appropriate black paint for aluminum, paint prep, painting technique, and anything else I might need to know to get a clean finish?

Help is appreciated.

Thomas Carlson
Manufacturer - Tulsa, OK USA
October 20, 2009

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: