Aloha, fun & authoritative answers -- no cost, no registration, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

Application of tungsten disulphate dry powder

Having received enquiries for the application of tungsten disulphate powder (0.5 micron)I would appreciate any indication on how this is applied to both aluminium and ferrous metals. All that I have been able to establish is that it is an impingement process and assume this is achieved by the use of a pressured air supply in side a booth of some type. Any additional info would be most gratefully received. thanks

Alan Burbidge
plating shop empolyee - Oxfordshire, UK
September 23, 2009

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: