Aloha, fun & authoritative answers -- no cost, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Metal finishing Q&As since 1989

-----

Black line on extrusion after anodize

I work in extrusion factory in Thailand for production control my problem is extrusion after we send to Anodize show black line though along extrusion length.Black line appear especially on join weld area after extruded we not see any line any more we can see only after Anodize. Alloy we use is 6060,6061 and 6082 black line is often occur in hallow profile.

Please advise what should I do to improve.

Thank you for your advise.

Nakaret Ruksataya
Production - Lamphun,Thailand
August 17, 2009

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: