People helping each other -- No AI, no cost, no reg'n, no damn popups
(As an Amazon Associate & eBay Partner we earn from qualifying purchases)

finishing.com -- The Home Page of the Finishing Industry

Thread 526/08

Weak adhesion problem

July 14, 2009

sir;

I'm an employee in a flexible packaging company in the philippines, our problem usually is weak adhesion on both sides of the laminates, opp and vaccum metallized oriented polypropylene. we used solvent free machine - nordmecanicca running at 315 meters per minute. we used morfree 698and c79 adhesive at 48 hours curing time ambient temp.

thank you so much for your action.

Bob Casan
employee - Philippines
publicly reply to Bob Casan

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: