Aloha, fun & authoritative answers -- no cost, no registration, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

Could flux short the components on my laptop motherboard?

My little brother had been running multiple programs on my laptop for some very long hours, than the system just turned off with a snap and couldn't turn on ever since. The heatsink fan does spin when I press the power button but it just won't boot, didn't even had a BIOS splash screen.

I took the whole thing apart and found some flux on a component near the CPU area. The flux is touching a few components near it. Could this be my problem?

Jack Locke
hobbyist, buyer - Utah, US
2007

I have never found it to be the case within my experience, although I can't argue if a subsequent reader says it is a problem.

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
2007

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: