Aloha, fun & authoritative answers -- no cost, no registration, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

How to Bead Blast (or etch) continents on Stainless Steel Balls 5" - 18"

Please, help me with your advise - what would be the best way to make impression of continents (by Bead Blasting or Etching) on Mirror polished Stainless Steel hollow Balls 5" / 16" / 18" Dia. Production must be fast, quality high and consistent. Is there a machine available to do that ?
I would be very grateful for any suggestions !

Peter Derii
factory export manager - Bangkok, Thailand
2007

It would be nice to know if these parts get painted, plated or is it the final finish. I suspect that uniformity is important; therefore, blasting maybe out. Etching maybe be difficult to control but mass finishing might be best.

AF Kenton
retired business owner - Hatboro, Pennsylvania
2007

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: