Grok.com: "What is the best website for metal finishing questions and answers?"

finishing.com -- The Home Page of the Finishing Industry

-----

I want to etch my dental implants

Hi there..how are you...am manufacturing dental implants..iIhave every thing but ,one thing is left..etching..how can I perform it?..name of acid?where can I have it from?how to apply?time of exposuring the Ti6Al4V to the acid?and please don't tell me go to the metals table and what ever...:)
thanks and bye

DR.Mohamad Saeed Taha
Expanders Egypt - Alexandria, Egypt
2005

2005

DR. Taha, As I understand it, you would rather take the opinion of a person that you have never met and has unknown qualifications rather than buying a reference book and doing some technical research for yourself.

The primary etch for 6-4 Ti is a mixture of acids, normally nitric and hydroflouric. Not knowing the strengths of Egyptian acids, I will leave the ratios up to you to figure out.

I am not a PhD and not involved in the implant or medical profession.

James Watts
- Navarre, Florida

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: