No cost, no registration, no passwords -- just aloha, fun & authoritative answers
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

Galvanized vs. zinc anodized bicycle chain

Simple answer . I am a cyclist, and I want to protect my horse with the best chain available. I was told that dipped galvanized steel was better than zinc anodized but the gentleman could not give me a simple scientific explanation.

Nathaniel Beal
cyclist - San Rafael, California, USA
2005

There rarely are simple answers, and your question is no exception. The truth is a consumer can virtually never make a purchasing decision based on the alleged technology of the metal finishing, but only on the reputation of the supplier. I doubt that anyone is offering zinc anodized chain, but if they are it's probably the best, on the principle that this is an expensive, exotic technology, so if they're doing it there is little point in cutting corners.

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
2005

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: