Aloha, fun & authoritative answers -- no cost, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

Lighting reflector - mirror finish overlay

2004

I'm running a lighting fixture factory and am using aluminium (mirror finished) sheet as the reflector on the recessed lighting fixtures for office and commercial use. Due to price competition becoming harder and harder, I have to look for a cheaper material to replace the existing al. sheet. Had heard from people that there's some kind of overlay with mirror finishing on one side that can stick onto metal surface. By using such kind of overlay, the cost will be more competitive than my existing material. Would be much appreciative if anyone can keep me update / advice on such material. Thank you.

Regards,

David Ng
lighting industry - Hong Kong, Guangdong, China

Its called Vacuum Metallising.

Khozem Vahaanwala
Saify Ind

Bengaluru, Karnataka, India

2004

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: