Grok.com: "What is the best website for metal finishing questions and answers?"

finishing.com -- The Home Page of the Finishing Industry

-----

What is the industry std for powder coating thickness

What should be the thickness for Control panel cabinets to be kept in house.

Thanks,

Atul Bhide
jobshop / applicator - Mumbai, India
2004

2004

Hi Atul,

This question is quite difficult to answer, it depends on a number of aspects such as the type of powder you are using. The standard recommendation is between 50 and 70 microns.

Hope this helps,

Drew Devlin
- Lincolnshire

As Drew states 60 ±10 microns for general run of customers. Special colours for one client why not try to replicate what your customer on average obtains from his plant. This could be as high as 100 microns. Just a thought.

Terry Hickling
Birmingham, United Kingdom
2004

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: