Aloha, fun & authoritative answers -- no cost, no registration, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

US 4 FINISH

I have to export to France Stainless Steel Parts in US4 Finish. Please advise how I can reach this finish on a raw Investment Casting Part.

Thanks & Regards,

Prakash Munshi
EXPORTS OF METAL PRODUCTS - MUMBAI, MAHARASHTRA, India
2003

An easy way would be to job them out to a shop that knows how to do it. Prakash. The option is usually there to simply buy the services you need.

I'm not trying to be glib or facetious, just noting that while this forum works fine for peers to share little tips, asking for the free wholesale transfer of an entire technology may be a little unrealistic. Please describe what you've tried and what difficulties you've stumbled into, and maybe we can make some progress. Thanks and good luck!

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
2003

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: