People helping each other -- No AI, no cost, no reg'n, no damn popups
(As an Amazon Associate & eBay Partner we earn from qualifying purchases)

finishing.com -- The Home Page of the Finishing Industry

Thread 249/14

400 Micrometer Ni-P

2003

Dear sir,

Can I obtain 400 Micrometer Ni-P on Al-Si from electroless process?

Thank you,

Harouni
University - Esfahan, Iran
publicly reply to Harouni

I have done some more research and even done some experimenting, although I think my current is to high and I am going to electronics store tomorrow to try to remedy that. I am now asking can I electroform lead with an acid-copper solution, basically forming a copper jacket for the bullet by building up of copper on copper.

Thanks,

Craig McAdam
hobbyist - Macon, Georgia, USA
2004
publicly reply to Craig McAdam

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: