Grok.com: "What is the best website for metal finishing questions and answers?"

finishing.com -- The Home Page of the Finishing Industry

-----

Coatings for aluminum mountain bike disk rotors

I am currently researching using a Aluminum Disk Rotor on mountain bike application, we currently make atv and motorcycle rotors and use a Liquid static coating, Heat Resistant. But since the material is aluminum what would be an ideal coating for the disk; T6 temper. Can the disk be anodized, or what type of coating would be recommended? Please share with me any insight to my question, any suggestions welcomed.....

Tony Marchman
- Lugoff, South Carolina
2003

What are the pads made of? Electroless nickel or anodize would be possible candidates for your application.

Todd Osmolski
- Charlotte, North Carolina, USA
2003

I made an aluminum rotor for my mountain bike. I had it hard coat anodized but my pads did not grip on the coating too well. I had to squeeze the lever much harder.

Sal Fortuna
- Malabar, Florida
2003

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: