People helping each other -- No AI, no cost, no reg'n, no damn popups
(As an Amazon Associate & eBay Partner we earn from qualifying purchases)

finishing.com -- The Home Page of the Finishing Industry

Thread 203/90

Degreasing laminations

2003

I want to degrease laminations of a ballast after it has been assembled before dipping into paint. What process is recommended as it should penetrate deep into the laminations and the coil.

Regards,

Javaid Iqbal
Paklite - Gujranwala, Pakistan
publicly reply to Javaid Iqbal

A wild guess-vapor degreasing followed by a vacuum drying process. My real belief is that nothing will work after assembly. James Watts
- Navarre, Florida
2003
publicly reply to James Watts

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: