Mr. Rogers: "Look for the Helpers. You will always find people who are helping."
As an Amazon Associate & eBay Partner: we earn from qualifying purchases

Home /
T.O.C.
Fun
FAQs
Good
Books
Ref.
Libr.
Adver-
tise
Help
Wanted
Current
Q&A's
Site 🔍
Search
finishing.com -- The Home Page of the Finishing Industry


  Thread 185/56

BRASS JIGS



HI,

I WOULD LIKE TO KNOW IF USING BRASS MADE JIGS AND RACKS COULD CREATE PROBLEM FOR ELECTROPLATING.

THANKS,

Ally Goolamhossen
Mcpil - Portlouis, Mauritius
2002
publicly reply to Ally Goolamhossen


Ally, be more specific. Brass is fine for most, but not all plating racks. James Watts
- Navarre, Florida
2002
publicly reply to James Watts



(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread


Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

Finishing
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g,
& Software


About/Contact  -  Privacy Policy  -  ©1995-2025 finishing.com, Pine Beach, New Jersey, USA  -  about "affil links"