No AI, no cost, no reg'n, no popups
As an Amazon Associate & eBay Partner: we earn from qualifying purchases

finishing.com -- The Home Page of the Finishing Industry

-----

Mold making

2002

Hi,

I am performing a nickel plating on aluminium and want to know what procedures exists so as to remove the aluminium and thus making a mold of nickel.

Thanks,

Chandan Boodhoo
- Mauritius

I may be misunderstanding your question, Chandran, but you can just dissolve the aluminum in sodium hydroxide. The process of making articles this way is called electroforming. Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
2002

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: