Aloha, fun & authoritative answers -- no cost, no registration, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

Electropolishing semiconductor wafers

Does anyone know about the feasibility of electropolishing semiconductor wafers?

Michael Liu Taylor
specialty stainless steel distributor - Dallas, Texas
1998

I think that the use of electropolishing implies that the surface to be treated must be somewhat conductive (copper, steel, gold, etc.).

Semiconductors would not fit the bill. They would more likely be chemically etched or polished without the use of electricity (unless you were trying to electropolish a conductive coating on the surface of the semiconductor wafer).

I hope this makes sense.

Bill Vins
microwave & cable assemblies - Mesa (what a place-a), Arizona
1997

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: