No cost, no registration, no passwords -- just aloha, fun & authoritative answers
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

Titanium plating onto 3d part printed from acrylic resin

I am researching the possibility of titanium plating 3 dimensional printed parts for the purpose of implants to the human body. The parts printed are made from Acrylic UV cured resin This material can withstand approximately 50° C. is this achievable with any method you know of?

Jerry Walton
- Stoke on Trent, UK
July 21, 2011

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: