The Last Stand of the web we knew & loved: no cost, no reg'n, no popups
As an Amazon Associate & eBay Partner: we earn from qualifying purchases

finishing.com -- The Home Page of the Finishing Industry

-----

Accurate Blackening Process for Stator Stack

2001

We are a company located in India, who want to Blacken Stator stacks only up to 2 microns and should be able to sustain 48 hours of salt spray test. The stators have an OD of 53.5 mm and Id is 29 mm.

Kindly suggest the best method. Thanking you,

Mihir Apte
- Mumbai, Maharashtra, India

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: