No passwords, No popups, No cost
we earn from your eBay & Amazon purchases

Home /
T.O.C.
Fun
FAQs
Good
Books
Ref.
Libr.
Adver-
tise
Help
Wanted
Current
Q&A's
Site 🔍
Search
curated with aloha by
ted_yosem
Ted Mooney, P.E. RET
- Pine Beach, NJ
finishing.com -- The Home Page of the Finishing Industry


  pub
  The authoritative public forum
  for Metal Finishing since 1989

-----

Dry Grinding D 2





To dry grind or to wet grind. Is it really a personal preference? Working with molds for 2 yrs. using S-7 we always wet ground our blocks with consecutive and consistent results. Now, working on dies, using D-2, this company's practice is to dry grind everything. It's almost "uncomfortable" to grind w/o coolant. The supervisor's theory is that the coolant puts some kind of "coating" or build-up on the D-2, thus causing a problem. Is there any evidence to substantiate this claim?

Tom Filas
Morgan Marshal Ind. - Cedar Lake, IN, U.S.A.
2001




(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

Finishing
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g,
& Software


About/Contact  -  Privacy Policy  -  ©1995-2024 finishing.com, Pine Beach, New Jersey, USA  -  about "affil links"