curated with aloha by
Ted Mooney, P.E. RET
- Pine Beach, NJ
Ted Mooney, P.E. RET
- Pine Beach, NJ
The authoritative public forum
for Metal Finishing since 1989
-----
Brass Plating
Dear Sir,
We require plating chemicals & process information on brass plating on steel tubes of 3/8" OD. Plating thickness required is approximately 10 microns to 50 microns
Harshad BankerBanco Products (I) Limited - Vadodara, Gujarat, India
2001
(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)
Q, A, or Comment on THIS thread -or- Start a NEW Thread
Q, A, or Comment on THIS thread -or- Start a NEW Thread