No passwords, No popups, No cost
we earn from your eBay & Amazon purchases

Home /
T.O.C.
Fun
FAQs
Good
Books
Ref.
Libr.
Adver-
tise
Help
Wanted
Current
Q&A's
Site 🔍
Search
curated with aloha by
ted_yosem
Ted Mooney, P.E. RET
- Pine Beach, NJ
finishing.com -- The Home Page of the Finishing Industry


  pub
  The authoritative public forum
  for Metal Finishing since 1989

-----

Certification of Sulfuric Acid Anodizing voltage

none
finishing.com is made possible by ...
this text gets replaced with bannerText
spacer gets replaced with bannerImages


Q. I recently had a recertification needed on our sulfuric tank. It only passed the voltage requirement because we took the bar out of the tank. Amperage runs fine with the bar in the tank. Any advice?

Tyler Barnhart
- Chanute Kansas
October 14, 2022




(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

Finishing
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g,
& Software


About/Contact  -  Privacy Policy  -  ©1995-2024 finishing.com, Pine Beach, New Jersey, USA  -  about "affil links"