Aloha, fun & authoritative answers -- no cost, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Metal finishing Q&As since 1989

-----

Can Magnetic Jigs/Racks be used for Hard Chrome Plating?

adv.
this text gets replaced with bannerText

Q. Hi Everyone

I am Tony from India

I am working in R&D department in a Plating Company.

I have a very critical question, please solve this:
Can we use Magnetic Jigs in hard chrome plating? I have a small component of 3 mm dia and 7 mm length, I need 15-micron plating on its outer surface. I want to hold the component top side by a magnet and current transfer through the magnet.

Tony Yadav
- Delhi India
November 8, 2021

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: