Aloha, fun & authoritative answers -- no cost, no registration, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

Sandblast mask / sandblast resistant paint

April 10, 2015

Q. Dear sir,
I'm a manufacturer of metal coins like silver, gold, copper, brass, etc.
I also manufacture our own dies with Acid etching.
I want to sandblast on my dies but covering some area with Sandblast resist paint.
So please suggest some helpful paint or resin.
Regards,

Kaushal patni
coins manufacturer - India

April 2015

Hi Kaushal. I'm not familiar with paintable products being used for this purpose, but vinyl adhesive tapes/sheets are. Look for terms like "Hartco SandMask", "3M Buttercut Sandblast Resist Stencils", or similar products from Anchor or Edco. Good luck.

Regards,

Ted Mooney, P.E. RET
Striving to live Aloha
finishing.com - Pine Beach, New Jersey

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: