Aloha, fun & authoritative answers -- no cost, no registration, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

Electropolishing Recessed Areas

most of my experience in electropolishing has been on machined parts with relatively simple shapes. we have an opportunity to get some sheetmetal work. there will be shapes with deep recesses, and most likely some racking difficulties. where can I get help on rack design, and some suggestions on polishing in those low current density areas? this will be high volume work.

ken phillips
- houston, texas
2000

Ken:

I would be happy to help you design racks for your sheet metal parts. Please fax me drawings or email photos of the parts.

Dan Weaver
- Toccoa, Georgia
2000

2000

Ken:

Metal Coating Process Corporation can furnish several levels of assistance on your racks:

1. We can design and build the racks based on blueprints of your parts.

2. We can provide an on-site consulting service to show you how to rack the parts for electropolishing.

3. We offer a periodic one-day seminar on the principles of rack design.

We are listed in the Suppliers Directory on finishing.com, and there is a link to our own web site.

Ed Bayha
Metal Coating Process Corporation - Charlotte, North Carolina

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: