Where the world gathers for
plating, anodizing, & finishing Q&As since 1989
-----
Can a Dip Brazed Aluminum Chassis Be Hard Anodized
September 13, 2012
Q. As the title asks: Can a 6061 aluminum chassis that has been dip brazed be hard anodized? The filler is aluminum so it seems like it should be possible but I don't know if trapped salts would be an issue. In addition, this chassis must meet IP67. If it can be done, what issues can I expect?
Dan Timmons
Product Design - Endicott, New York
finishing.com is made possible by ...
this text gets replaced with bannerText
Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.
If you are seeking a product or service related to metal finishing, please check these Directories: