Summary for tin coating for maraging steel Discussion
TiN coating for 300-grade maraging steel is questioned in this short thread, but the only answer shown does not endorse or reject the finish. Arthur O'Donnell asks whether Titanium Nitride is a good finish for a highly stressed maraging steel part made to MIL-S-46850, type 3, grade 300. The response from an unnamed answerer is a cautionary challenge rather than a recommendation: “Why do you want to deposit TiN on the maraging steel?” That suggests the key issue is not simply whether TiN can be applied, but what performance goal the coating is meant to achieve on a highly stressed component. Because no further technical discussion is included in the excerpt, the thread leaves the question open and implies that the intended purpose of the coating should be clarified before choosing it.
Q. I have a highly stressed part that is steel, maraging per MIL-S-46850, type 3, grade 300.
Is Titanium Nitride a good finish to use on this material?
Arthur O’Donnell
– Gilbert, Arizona, US
August 29, 2012
A. Why do you want to deposit TiN on the maraging steel?

Jim Treglio – scwineryreview.com
PVD Consultant & Wine Lover
San Diego, California
August 31, 2012