Home /
T.O.C.
FAQs
 
Good
Books
Ref.
Libr.
Advertise
 
Help
Wanted
Current
Q&A's
Search 🔍
the Site
pub Where the world gathers for
plating, anodizing, & finishing Q&As since 1989





-----

Welt defect on GI products




August 9, 2012

Q. We at times have the issue of welts on our GI products. It happens once in a while and in batches. I tried to find some literature but unfortunately I have not come across one. It looks like smaller coil breaks but there is nothing on the substrate. I have a couple of micros and pics to share. Any information will be greatly appreciated.

58778

Thank you,

Abhilash Dash
galvanizing metallurgist - Columbus


none
finishing.com is made possible by ...
this text gets replaced with bannerText
spacer gets replaced with bannerImages



(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact    -    Privacy Policy    -    ©1995-2023 finishing.com, Pine Beach, New Jersey, USA