Aloha, fun & authoritative answers -- no cost, no registration, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

Need a service to change our Hot-dip galvanizing kettle

May 5, 2011

Dear Sirs,
We are a steel company in Dunaujvaros, Hungary. Later this year we are going to replace our old kettle to a new one. The new galvanizing kettle has already been purchased. The capacity of the kettle is 120 t, the quantity of hot zinc is about 110-115 t. Connected to this replacement we need services for pumping out the fluid 460° C hot zinc from the old kettle into Dewar vessels, holding the zinc in Dewar vessels, then pumping back the zinc into the built-in new galvanizing kettle.
Could you help me please to find companies in Europe that offer the needed services of pumping out and back and holding hot the fluid zinc, connected to kettle change.
Thanks in advance for your help.

Csaba Szatmari
buyer - Dunaujvaros, Hungary

Ed. note: Sorry, this RFQ is old & outdated, so contact info is no longer available. However, if you feel that something technical should be said in reply, please post it; no public commercial suggestions please ( huh? why?)

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: