Home /
T.O.C.
FAQs
 
Good
Books
Ref.
Libr.
Advertise
Here
Help
Wanted
Current
Q&A's
Search 🔍
the Site
pub Where the world gathers for
plating, anodizing, & finishing Q&As since 1989





-----

Silver Master problem on polyester





December 2, 2010

We are having problems with the Silver Master on Polyester, no problem on glass. We have to use a lot of wetting agent on the PET or Polycarbonate to get successful shims. Our nickel sulphamate bath parameters are on target.

56266-1 56266-2

Any ideas? Could it be the Reducer, spray gun ratio?

Cheers

Alex Mag
Consultant - Sydney



December 22, 2010

Problem solved, please see the following link www.finishing .com/456/20.shtml

Cheers

Alex
- Sydney


none
finishing.com is made possible by ...
this text gets replaced with bannerText
spacer gets replaced with bannerImages

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact    -    Privacy Policy    -    ©1995-2023 finishing.com, Pine Beach, New Jersey, USA