Aloha, fun & authoritative answers -- no cost, no registration, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

Shelf life of epoxy powder

October 16, 2010

sir
we have a big amount of epoxy hybrid resin powder and the production date was may 2009, when spraying the powder and cure it after doing the impact test after 2 hours of curing it did not passed mean while when doing anther fresh powder produced in june 2010 it passed successfully, we checked all the affecting parameters
we have 2 choice
1- to sell this powder as a scrap
2- try to operate it
do you have any recommendations
by the way it is a black powder and when we elevate the curing condition it did not passed
yours

Joseph Gerges
processor - Egypt

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: