As a member of the eBay Partner Network & Amazon Affiliate we receive compensation for qualifying purchases

Home /
T.O.C.
FAQs
 
Good
Books
Ref.
Libr.
Advertise
Here
Help
Wanted
Current
Q&A's
Search 🔍
the Site
pub Where the world gathers for
plating, anodizing, & finishing Q&As since 1989





-----

Reworking rust dots on zinc plated product




We have a forged product on which we do zinc plating with blue passivation which got small rusty dots because of sea weather in transport. Is there any method of rework?

Chandu Bhojane
engineer - Pune, India
May 18, 2010


Strip and replate. Prevent this from happening by proper packaging of DRY parts and use PMI paper in the container.

James Watts
- Navarre, Florida
May 19, 2010




(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact  -  Privacy Policy  -  ©1995-2024 finishing.com, Pine Beach, New Jersey, USA  -  about "affil links"