People helping each other -- No AI, no cost, no reg'n, no damn popups
(As an Amazon Associate & eBay Partner we earn from qualifying purchases)

finishing.com -- The Home Page of the Finishing Industry

-----

Passivation of copper and copper alloy waveguide

Some years ago we usually performed a passivation treatment on copper and brass waveguides by means of Iridite 7/P. Could anybody suggest us a reference to MIL or other standards for the requirements wrt salt spray fog?

Pasquale Cirese
technological process QA - Firenze, Italia
April 16, 2009

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: