Where the world gathers for
plating, anodizing, & finishing Q&As since 1989
-----
Will Ameron 2/400 adhere to sandblasted Inconel?
November 30, 2008
We're work on offshore platform and there's quite of Inconel piping and wanted to know if the Inconel piping was sandblasted can Ameron 2/400 be applied and have a good adhesion?
Kennedy Johnson
Inspector - Venice, Louisiana
December 9, 2008
Sounds like it would be fine. However not mentioned on data sheet. Can you contact PPG Ameron tech people?
Regards
Jim Wood
- Concord, California, USA
finishing.com is made possible by ...
this text gets replaced with bannerText
Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.
If you are seeking a product or service related to metal finishing, please check these Directories: