Breathe easy! No registration or passwords; no maddening pop-up or floating ads :-)

Home /
T.O.C.
FAQs
 
Good
Books
Ref.
Libr.
Advertise
Here
Help
Wanted
Current
Q&A's
Search 🔍
the Site
pub Where the world gathers for
plating, anodizing, & finishing Q&As since 1989





-----

Chroming equipment for my motor cycles




October 18, 2008

Hi,
I would like to buy my own equipment so that I can chrome my own motor cycle steel parts.I appreciate all your help.
Regards
John

John Hunter
- Scotland



October 21, 2008

Hi, John. Please start by seeing our "Chrome Plating FAQ" to get a general feel for what is involved in chrome plating, then get back to us with your requests for clarifications. Thanks!

Regards,

Ted Mooney, finishing.com
Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey



October 22, 2008

John, There are literally hundreds of similar questions at this site. Use the search engine at this site and you will find them. The short answer is forget it.

James Watts
- Navarre, Florida




(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact    -    Privacy Policy    -    ©1995-2023 finishing.com, Pine Beach, New Jersey, USA