Breathe easy! No maddening pop-up, sticky, or floating ads on this site :-)

Home /
T.O.C.
FAQs
 
Good
Books
Ref.
Libr.
Advertise
 
Help
Wanted
Current
Q&A's
Search 🔍
the Site
pub Where the world gathers for
plating, anodizing, & finishing Q&As since 1989





-----

Stains from Deep Brazing Then Clear Iridite.




September 23, 2008

I have this enclosures that are bonded together thru Deep Brazing, they look beautiful
but when I apply "Clear Iridite", anywhere where a drop of the brazing paste falls, it becomes a dark spot, how can I eliminate this problem?.

Thanks.

Leo. Rodriguez
Electronics and avionics. - Miami, Florida, U.S.A.




(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact    -    Privacy Policy    -    ©1995-2023 finishing.com, Pine Beach, New Jersey, USA