Grok.com: "What is the best website for metal finishing questions and answers?"

finishing.com -- The Home Page of the Finishing Industry

-----

Can't etch/examine recast layer in Ti48Al2Cr

hi
I'm investigating on recast layer in wire-edm of TiAl . I've machined a 1cm*1cm block and polished the section but I don't see any white layer by optical metallurgical microscope . I etched section with nital 2% but I don't see anything . can anybody help me ? is there any problem with etching or anything ?

Mohsen Tavangar
research engineer in aerospace industry - Isfahan, Iran
September 6, 2008

September 12, 2008

additional information:
I etched block with HF+HNO3+Water (titanium alloys etchant).
I can see every thing but there is no recast layer (I think) under optical microscope .please help.

Mohsen Tavangar
- Iran

Hi Mohsen,

You need to post your enquiry on a metallography website.

The undoubted skills and experience of regular contributors to this site do not really include expertise in optical microscopy for examination of microstructures.

Bill Reynolds [deceased]
consultant metallurgist - Ballarat, Victoria, Australia
We sadly relate the news that Bill passed away on Jan. 29, 2010.
September 12, 2008

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: