No registration or passwords; no pop-up ads -- just aloha, fun, & answers.
(as an eBay Partner & Amazon Affiliate earns from qualifying purchases).
Home /
T.O.C.
Fun
FAQs
Good
Books
Ref.
Libr.
Advertise
 
Help
Wanted
Current
Q&A's
Site 🔍
Search
pub  Where the
world gathers for metal finishing
Q&As since 1989



-----

Tracking with crowned pulley wheels





I am looking for information regarding crowned pulley wheels. I am trying to modify our equipment to allow better tracking of our product. I already tried a crowned pulley and one gauge of material tracked perfectly down the middle of the wheel, the thicker gauge stayed to the side. I am looking for information that will explain what crowned radius I should use for various material thicknesses. Any help?

Greg Churley
Delphi - Warren, Ohio
2000


see this: http://www.beltcorp.com/woven/pulleycrowning.html

Adrian Urlea
- Toronto, Canada
2004




(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact  -  Privacy Policy  -  ©1995-2024 finishing.com, Pine Beach, New Jersey, USA  -  about "affil links"