Aloha, fun & authoritative answers -- no cost, no registration, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

Nickel Cobalt alloy plating

Q. We wish to plate Nickel Cobalt alloy (10%, 20%). The deposit should be hard, stress free.

Any suggestions?

Thanks, VIKRAM

Vikram Dogra
Irusha India - Chandigarh, India
2000

A. Dear Mr. Dogra,

We have done in the past some work for a local customer with a continuous plating (strip line) Ni-Co bath. The job was specific for the manufacturing of battery bodies requiring deep stamping as well as an specific electric characteristic.

Domingos J C Spinelli
- SB Campo Sao Paulo Brazil
2000

A. It should be no problem, Ni/Co is used in many applications.

Tom Pullizzi
Falls Township, Pennsylvania
2000

RFQ: Does anyone know of a supplier of Nickel-Cobalt plating equipment, solutions, or any shop that can do a small experimental run?

Thanks

Dana T [last name deleted for privacy by Editor]
- Boulder, Colorado, USA
2001

Call NiCoForm [a finishing.com supporting advertiser] [for your experimental run].

Russell Richter
- Danbury, Connecticut, USA
2001

adv.

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: