Aloha, fun & authoritative answers -- no cost, no registration, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

Heat Treat Differences between MIL-C-26074C and Subsequent Revisions

March 3, 2008

We have numerous old drawings where a note specifies heat treat to section 3.5.2 of MIL-C-26074C. Recently a plating provider asked what section this heat treat became in MIL-C-26074D or MIL-C-26074E. I'd like to review a copy of the MIL-C-26074C to verify before making a recommendation.

So, Can anyone share a copy of MIL-C-26074C or at least the heat-treat portion of MIL-C-26074C? Or failing that, can anyone offer any help correlating paragraph numbers between the revisions?

thanks

William Steinhour
Use many plated parts in our product - Colorado Springs

Bill

Go to

assist.daps.dla.mil/quicksearch/

Enter the specification in the Document ID field.

Try using MIL-DTL-26074F NOT 1

Willie Alexander
- Colorado Springs, Colorado
March 5, 2008

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: