Summary for cie l*a*b polyester powder Discussion
CIE L*A*B polyester powder no texture is the issue Sean Halloran raises when a customer specifies L-86.72, A-.20, B-4.97 and a 1.5-4.0 film thickness. The answer says this is not enough information by itself to confidently get the parts painted. According to the reply, gloss must also be specified along with the formulation and L*A*B values; the thickness is typical for powder coating and is less critical. The responder also warns that the finish may need to be custom made, so it should not be quoted until suppliers are checked for an in-stock paint that meets the requirements. In short, the thread emphasizes that color coordinates alone do not fully define a powder coating finish, especially when a no-texture appearance is required.
My customer is calling out a CIE L*A*B polyester powder no texture
L-86.72 A-.20 B-4.97
1.5-4.0 FILM THICKNESS
Is this enough information to get these parts painted?
Sean Halloran
job shop – Webster, New York
2007
A. You need the gloss in addition to the formulation and L*A*B*’s, the thickness is typical to powder so it’s not as important. This might have to be custom made so don’t quote it until you find out if any of your suppliers have a paint in stock that will meet the requirements.

Sheldon Taylor
supply chain electronics
Wake Forest, North Carolina