People helping each other -- No AI, no cost, no reg'n, no damn popups
(As an Amazon Associate & eBay Partner we earn from qualifying purchases)

finishing.com -- The Home Page of the Finishing Industry

Thread 422/38

What is the Confidence Interval For MIL-STD-105E?

Hi All,

Can anyone tell me what the confidence interval is for the normal, tightened, and reduced inspections in the MIL-STD-105E? Is this answered in its Operational-Characteristic (OC) curve?

Salvatore Pontillo
Quality Systems Engineer - Melville, New York
2006
publicly reply to Salvatore Pontillo

I want to know the same for 105D

Md. Al Bokor
- Dhaka, Bangladesh
2006
publicly reply to Md. Al Bokor

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: