No registration or passwords; no pop-up ads -- just aloha, fun, & answers.
(as an eBay Partner & Amazon Affiliate earns from qualifying purchases).
Home /
T.O.C.
Fun
FAQs
Good
Books
Ref.
Libr.
Advertise
 
Help
Wanted
Current
Q&A's
Site 🔍
Search
pub  Where the
world gathers for metal finishing
Q&As since 1989



-----

Info needed on High temp powder coat for exhaust systems




Are there any sources for a high temp powder coat for exhausts, and the like? And what would be the best way to cure it?

Zack Alderfer
- Pennsburg, Pennsylvania
2000

Ed. note: Sorry, this RFQ is old & outdated, so contact info is no longer available. However, if you feel that something technical should be said in reply, please post it; no public commercial suggestions please ( huh? why?)

There's a company called Jet-Hot Coatings, we've used their product on motorcycle racing exhausts for years, less so now that most aftermarket exhausts are produced in stainless. The company claims the coating remains stable at up to 2000 deg F.

Joe Delaney
- Miami Beach Florida
2000



I am looking for a source of supply of high temp. waterbase paint (600° F. Also powder coat as well.

Jack Boisseau
vacuum technologies - Lexington, Massachusetts USA
2000

Ed. note: Sorry, this RFQ is old & outdated, so contact info is no longer available. However, if you feel that something technical should be said in reply, please post it; no public commercial suggestions please ( huh? why?)




I am looking for a company located in Argentina (preferentially near Buenos Aires) that does hot-jet coatings.

Dr. Roberto B [last name deleted for privacy by Editor]
- Johnston, Iowa, USA
2003

Ed. note: Sorry, this RFQ is old & outdated, so contact info is no longer available. However, if you feel that something technical should be said in reply, please post it; no public commercial suggestions please ( huh? why?)



----
Ed. note: We appended your inquiry to a thread about "Jet-Hot", Dr. B. If we have misunderstood the kind of coating you are looking for, please advice.




(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories:

 
Jobshops
Capital
Equipment
Chemicals &
Consumables
Consult'g, Train'g
& Software


About/Contact  -  Privacy Policy  -  ©1995-2024 finishing.com, Pine Beach, New Jersey, USA  -  about "affil links"