Aloha, fun & authoritative answers -- no cost, no registration, no passwords, no popups
(as an eBay Partner & Amazon Affiliate we earn from qualifying purchases)

Where the
world gathers for metal finishing
Q&As since 1989

-----

What cause electroplating bleed out at casting coner edge and how to overcome?

2006

I am working as a production manager at a pressure Aluminum die casting house and our casting product mainly for hard disc industrial.
Our raw casting required electroplating process and we face e-coat bleed out defect.
Can someone please provide a solution.
LEE LEONG HUA
Aluminum pressure die casting - Malaysia

2006

Mr Lee

The problem is complex . It requires Hands on solving at site.

Reasons for bleed out are many.

Unless we know what you are doing and How, it will be quite difficult to come back with a meaningful solution which, I suggest is best handled by a professional, at SITE.

Regards,
asif_nurie
Asif Nurie [deceased]
- New Delhi, India
With deep regret we sadly advise that Asif passed away on Jan 24, 2016

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: